logo mascot
flag
 
 
Home --> Multilayer Plumbing Systems --> Installation (F1A & F1C)
     
  Step 1: Pipe cutting
1. Cut the pipe vertically and precisely with Rifeng pipe cutter.
  Step 2: Rounding and beveling
1. Round and bevel the end holes with the Rifeng plastic reamer.
  Step 3: Sleeving
1. Choose the right size fitting according to the pipe, put the nut over the pipe,side the compression ring over the pipe, make sure the mouth of the nut and the pipe faces the same direction.
 
2. Push the inserts into the pipe up to the shoulder, take care not to damage the O-ring.
  Step 4: Pressing
1. Follow the clamp tools instruction; position the clamp jaws so that their ends aligned with the end of the press sleeve. Shut the press clamp and begin the pressing procedure. It can only clamp once.
Notice:
* This installation manual is especially for the 14-32(mm) piping systems.
* For your safe connection, Rifeng pipes should be connected with approved fittings recommended by Rifeng.
 
 
 Rifeng 11.6mm Multilaye ...
 New Year Speech
 Rifeng is on its road t ...
  >>more
 
 
 
 
 
  About Rifeng | New Products | Certificates | FAQ | Contact Us | User Center |   Copyright ©2008-Rifeng, All Rights Reserved
line